M
AINTENANCE
Oven Door
CAUTION
NEVER place excessive weight on or stand on an open
oven door. This could cause the range to tip over, break
the door, or injure the user.
• NEVER attempt to open or close door or operate oven until
door is properly replaced.
• NEVER place fingers between hinge and front oven frame.
Hinge arms are spring mounted. If accidentally hit, the
hinge will slam shut against oven frame and could injure
your fingers.
Important: The oven door on a new range may feel "spongy"
when it is closed. This is normal and will decrease with use.
Oven Window
To protect the oven door window:
1. Do not use abrasive cleaning agents such as steel wool
scouring pads or powdered cleansers as they may scratch
the glass.
2. Do not hit the glass with pots, pans, furniture, toys, or
other objects.
3. Do not close the oven door until the oven racks are in
place.
Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
date.
Leveling Legs
CAUTION
Be sure the anti-tip bracket secures one of the rear
leveling legs to the floor. This bracket prevents the range
from accidentally tipping.
Be sure the range is leveled when installed. If
the range is not level, turn the leveling legs,
located at each corner of the range, until range
is level.
Oven Light
• Disconnect power to range before replacing light bulb.
• Use a dry potholder to prevent possible harm to hands
• Be sure bulb is cool before touching bulb.
• Do not touch hot bulb with a damp cloth as this may cause
To Replace Oven Light Bulb:
1. When oven is cool, hold bulb cover in place, then slide wire
2. Remove bulb cover and light bulb.
3. Replace with a 40-watt appli-
4. Replace bulb cover and se-
5. Reconnect power to range. Reset clock.
Storage Drawer
Do not store plastic, paper products, food or flammable
materials in this drawer. The drawer may become too warm
for these items when the oven is in use.
The storage drawer can be removed to allow you to clean
under the range.
To remove:
1. Empty drawer and pull out to the first stop position.
2. Lift up the front of the drawer.
3. Pull out to the second stop position.
4. Grasp sides and lift drawer up and out.
To replace:
1. Fit the ends of the drawer glides into the rails in the range.
2. Lift up the front of the drawer and gently push in to the
3. Lift drawer up again and push until drawer is closed.
ANTI-TIP BRACKET
ANTI-TIP BRACKET
LEVELING LEG
LEVELING LEG
8
CAUTION
when replacing bulb.
the bulb to break.
retainer off cover. NOTE: Bulb cover will fall if not held in place
while removing wire retainer.
ance bulb.
cure with wire retainer.
CAUTION
first stop position.
BULB COVER
WIRE
RETAINER
(select models)