Introduction; How To Use The P-Comfort Knx - Gewiss CHORUS GWA9916 Instrucciones De Uso

INTRODUCTION

The P-Comfort KNX performs the function of controlling loads on the KNX BUS, measuring and
indicating the instantaneous active power and energy consumed and/or produced by the system, and is
able to monitor up to five absorption limit threshold levels. The device is also fitted with a local relay for
directly controlling a load/circuit. It's installed on a DIN rail inside an electric board or junction box. The
device supports KNX Data Secure: this technology increases the security of a KNX installation both
during start up as well as during normal operation through the exchange of encrypted telegrams.

HOW TO USE THE P-COMFORT KNX

The device is equipped with:
The device has a segmented display for viewing:
⑦
⑧ ⑨ ⑩ ⑪
pag. 18
1. Power supply phase input
2. Power supply neutral input
3. Neutral output for measuring instantaneous power
4. Local relay output (Normally Closed contact)
5. Local relay common input
6. Local relay output (Normally Open contact)
Backward push-button
Forward push-button
SET SET push-button
7. the electric measurement/parameter visualised, the relative value and
signalling icons
8. Active parameter setting mode
9. Intervention of load control function, flashing icon until the reconnection is
completed. Load included in the control function; icon flashing if the load is
disconnected. Active power threshold; icon on if the threshold is exceeded,
off if not exceeded
10. Energy measurement unit kWh
11. Power measurement unit kW