Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Power threshold
Each load, including the local relay, can be temporarily excluded from/included in the control algorithm.
From the remote load screen, you can temporarily exclude/include the load from/in the control algorithm
by pressing the "SET" button key several times until the desired option is displayed: include load (1
"yes") or exclude load (2 "no"). To save the setting and return to the remote load screen, wait 3 seconds
without pressing any push-buttons.
The same also applies to the local relay, which can in turn be excluded/included by following the same
procedure:
Load control function Settings menu
In order to change the settings for the load control function, you need to access the appropriate settings
menu:
1. Go to the instantaneous power screen
2. Press the "SET" button key for at least 5 seconds, until the first parameter appears
3. The "SET" icon turns on to indicate the activation of the function
In the "SET" menu, the name of the first parameter is displayed in the 3 digits at the top and its current
value in the three digits at the bottom; the
previous/next parameter, and the "SET" button key can be pressed to start changing the value of the
parameter selected.
In particular, once the "SET" push-button is pressed, the current parameter setting flashes and the
and
push-buttons can be used to go through the various parameter values; a short press on the
button keys allows "fine" regulation (in unit increments) of the value, whereas holding them down
and
Duration (Sh. 1)
Hysteresis (t1.2)
1 min inactivity
Tripping of
1st load
Tripping of
2nd load
Tripping of
Reconnection
3rd load
of 1st load
and
button keys can be used to move to the
Reconnection
of 2nd load
pag. 21
Publicidad
Tabla de contenido
