Removal Of Protective Ring And Docking Cleaning; Exchange Of Carbon Brushes And Internal Lubrication - Pecol MCSDSP1500PRO Manual Del Usuario

4.3. Removal of protective ring and docking cleaning

The lubrication of the SDS Plus chuck docking should be frequently lubricated by special
grease applied at the time of installation of the tool (page 61). Use only the grease
recommended by PECOL that is specific to this power tool; the mixture of different
lubricants may permanently damage the equipment. In addition, this hammer works at
Do not use solvents to clean and remove the mass of the docking. Use P340 Industrial
Degreaser Spray for deep cleaning without damaging internal chuck components. For
more information, see page 71.

4.4. Exchange of carbon brushes and internal lubrication

The carbon brushes, together with the internal lubrication of this machine, are designed
to last long periods of operation. If it is necessary to change the carbon brushes or
perform internal lubrication according to the diagnosis in the Troubleshooting Chart
(page 68), refer the power tool to the PECOL Technical Assistance Service for proper
replacement and revision.
P.66
PT ES EN FR
high frequencies and high
hammering energy, so do not allow
abrasive particles, water and other
foreign elements to enter the
chuck's docking. If cleaning and
relubrication are necessary, remove
the protective ring, clean the entire
interior by removing old and dirty
grease and applying new grease.