How To Use - Black and Decker Digital Evolution D5000 Manual De Uso Y Cuidado

LCD Display Symbols
UTO OFF LOW TEMP HIGH TEMP
SELF CLE N ST NDBY
TEMP
F BRIC NO.
F BRIC N ME
UP/DOWN
FE TURES
0
5
Symbols
Surge-of-Steam
Spray
RE DY
uto Off
How to Use
This appliance is intended for household use only.
GETTING ST RTED
Remove any labels, stickers or tags attached to the body or soleplate of the iron.
Note: Use ordinary tap water for ironing. Do not use water processed through a home
softening system.
Important: For optimum performance, let the iron stand for 90 seconds before beginning to
iron.
Filling Water Tank
1. Grip each side of the water-fill cover and pull open (B).
B
2. Tilt the iron and using a clean measuring cup, pour water into
opening until the water reaches the M X level mark on the
water tank (C). Do not overfill.
3. Close the water-fill cover.
Note: If you need to add water while ironing, unplug the iron and
follow above steps.
C
4. Plug the iron into an electrical outlet.
• The iron beeps.
• Digital display window illuminates and fabric setting
1 ( CRYL) displays on the window with a flashing up
arrowand a circle around the iron symbol (D).
D
5. Once the iron reaches the preset temperature, it beeps and
the display shows the set temperature, fabric type and the iron
symbol without the circle (E).
SELECTING F BRIC TEMPER TURE
1. Read garment's label to help you determine fabric type.
Tip: If unsure of a garment's fiber, test a small area (on an inside
seam or hem) before ironing.
E
2. Once you determine the fabric type, select appropriate
temperature setting (from 1 to 7).
To set fabric temperature:
1. Use the pushbuttons on either side of the digital display
window (F).
2. Press the (+) button to select a higher setting.
3. Press the (-) button to select a lower setting.
Tip: s a guide, the digital display shows the setting number with
the corresponding fabric type.
F
6