MTD 300 Serie Manual Del Operador página 16

Ocultar thumbs Ver también para 300 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Drive Belt
NOTE: Replace the drive belt before reassembling the new auger
belt.
1.
Tip the snow thrower up and forward so that it rests on the
auger housing.
2.
Remove the spring that connects the transmission to a bolt
on the engine frame. See Figure 7-3.
NOTE: It may be easier to first remove the flange lock nut,
then use needle-nosed pliers to firmly grip spring and
remove from bolt.
Drive
Pulley
Belt Keeper
3.
Pivot the transmission forward to release pressure on the
drive belt. Remove belt from transmission pulley.
4.
Remove the drive belt from around the engine pulley, and
away from the unit.
5.
Place the new drive belt on the engine pulley. See Figure
7-2.
6.
Tilt the transmission forward and position the drive belt
onto the transmission pulley.
7.
Reconnect the spring to the bolt on the engine frame and
secure the transmission. Reinstall the flange lock nut.
8.
Install new auger belt.
9.
Reassemble the belt cover on the snow thrower
10.
Reassemble the belt keeper to the housing.
16
S
7— S
ection
ervice
Spring
Drive
Belt
Figure 7-3

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido