How Does My Landroid; Finding The Charging Base; Rain Sensors; Sensing The Boundary Wire - Worx LANDROID WG795E Instrucciones Originales

3.2 how does my Landroid

®
Your Landroid L is capable of doing things on its own. The Landroid
knows when it needs to go to its Charging Base (3) to charge, can
sense when it is raining, can stop itself if it senses a problem, and
knows to stop, draw back, and then turn around when it bumps into
something blocking its path, such as a person, pet, or other object.
®
The Landroid L will also automatically stop its Blade Turning Disc (16)
from rotating if it is lifted off the ground to prevent an accident.
A. Finding the charging base
When your Landroid
follow the Boundary Wire (23) in an anti-clockwise motion back to its
Charging Base. Landroid
Turning Disc when returning to its Charging Base. However , if it is
required to go back the Charge Base manually ( when you press the
home button), the Blade Turning Disc will rotate and cut the grass
near the boundary wire. So if you want to mow the grass near
the boundary wire, just press the home button. We suggest
you use this function when the battery power is more than
75%. You can check the battery power in the display.
B. Rain sensors
®
The Landroid L is fitted with a Rain Sensor (12) at its rear that will
detect rain drops and tell the Landroid
the Boundary Wire back to its Charging Base (See Fig. B).
®
The Landroid L is programmable to have a delay start function (0 –
180 mins) when it rains. When the rain sensors are wet, the Landroid
returns to its docking station. Only when the rain sensors become
dry will the Landroid
mowing immediately. If you want to command your Landroid
ahead and start mowing again before the time you have set under
10
the "Rain start delay" function, then press the Access Button (8),
®
dry the Landroid
Troubleshooting Guide for more details.
C. Sensing the boundary wire
®
The Landroid L always obeys the border set by the Boundary Wire and uses two sensors at its front to sense when it is
getting close. (See Fig. C) Before changing direction, the Landroid
*This is the recommended distance, because the Landroid
gauge to ensure proper installation.
D. Starting and stopping while mowing
If you would like to command the Landroid
mower. When pressed, the Landroid
mowing again until you have closed its Keypad Window (See Fig. D, E).
D
Lawn Mowing Robot
®
L needs to recharge, it will stop mowing and
®
L will automatically stop rotating its Blade
®
L to stop mowing and follow
®
L begin the delay start countdown or return to
L off, and close the Keypad Window (9) to tell it to mow again (See Fig. D, E). See the Programming and
®
L to stop mowing, then simply press the Access Button (8) on top of the
®
L will open its Keypad Window and await your further commands. It will not begin
®

L know where to go?

®
L
B
®
L
®
L to go
C
®
L will overrun the Boundary Wire around 25cm*.
®
L cannot calculate the distance itself. Use the provided distance
E
EN