Replacing The Drive Belt - EGO SNT2120AP Manual Del Operador

To replace the rubber augers:
(Fig. 24b)
Required tools:
◾
17/32" (13 mm) open-end wrench
(not included)
◾
3/16" (5 mm) hex wrench (supplied)
1. Wear gloves. Manually rotate the
auger to the appropriate position for
easy rubber auger disassembly.
2. Remove all securing bolts and nuts to take the rubber augers out.
3. Replace them with the new rubber augers, and securely tighten them.

REPLACING THE DRIVE BELT

If the drive belt becomes worn, oil-
soaked, excessively cracked, frayed, or
otherwise damaged, replace the belt.
WARNING:
unit and remove the battery pack(s) before
performing any maintenance task on your
snow blower.
Required tools (not included):
◾
T20 Torx screwdriver
◾
Needle Nose Pliers
1. Use a T20 Torx screwdriver (not
included) to remove the drive belt
cover by removing the 9 Torx screws
as shown in Fig. 25.
30
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2120AP/SNT2120AP-FC
Make sure to turn off the
24b
2 sets of bolts and nuts on
each auger (total of 8 sets)
25
Torx Screw
Drive Belt
Cover
Spring
26
Drive Belt
Auger Pulley
1 set of bolt, washer and nut on
each auger (total of 4 sets)
Hook
Idler Pulley
Motor
Pulley