Weidmuller AM 16 Instrucciones De Empleo página 4

en
English
1 A. Clamping jaws
B. Lever for setting blade position
C. Adjustment dial for depth of cut
D. Compression spring
E. Sharp edges for piercing insulation
F. Symbol, blade position for longitudinal cut
G. Symbol, blade position for circular cut
2 Setting the blade:
Lever B is pointing towards symbol G; circular cut is
selected. Select the blade position for longitudinal or
circular cut.
3
Open the clamping jaws.
Place tool over the cable.
4 Setting the depth of cut
Caution: Avoid cutting into the inner cables at all
costs.
5 Setting the depth of cut
Pull adjustment C dial in direction of arrow, turn and
release. The adjustment dial engages due to force of
spring.
6 Set the tool to circular cut (see figure 2) and turn the
tool around the cable.
7 Set the tool to longitudinal cut (see figure 2) and pull in
longitudinal direction along cable.
8 Cut open the insulation with the help of the sharp
edges.
9 Changing the blade
Open the clamping jaws A fully.
Pull out the pin in the direction of arrow.
9.1 Remove blade head assembly in direction of arrow.