Db500A Rear Panel - Samson dB500a Manual Del Usuario

dB500a Layout

dB500a REAR PANEL

MIC LEVEL – Used to adjust the volume of the micro-
1
phone input.
AMP / CLIP LED - Dual color LED lights Green when
2
amp is active, flashes Red when the amp is clipped or
stays Red indicating the amplifier is in protect mode.
LINE LEVEL – Used to control the level of the line
3
input.
LOW FREQUENCY - Controls the low band
4
of the Channel Equalizer, +/- 12 dB at 100Hz.
HIGH FREQUENCY - Controls the high band of the
5
Channel Equalizer, +/- 12 dB at 10kHz.
LIMITER SWITCH - Used to engage the dB500a's
6
Optimax dynamics processing. A red LED will illumi-
nate indicating the Optimax is on.
OUTPUT SWITCH - This switch is used to select the
7
signal that is sent to the Line Output. When the switch
is in the up position, the signal on the Line Output is
exactly the same as the signal on the Input. When the
switch is in the down position the Line Output carries
the MIX of the Mic and Line Inputs, as well as the High
and Low Equalizer and Low Filter.
8
1 2 3
15
SAMSON
AMP / CLIP
0 10
MIC LEVEL PROTECTION
P E A K
MIC INPUT LINE OUTPUT
14
13
dB500A
DESIGNED AND ENGINEERED IN THE UNITED STATES BY SAMSON TECHNOLOGIES
12
4
dB500a Rear Panel Layout
4
4 4 4 4
8 8 8 8
0 10 12 12 12 12
LINE LEVEL EQUALIZER
LOW 100Hz HIGH 10KHz
LINE INPUT
www.samsontech.com
11
5
6
7
8
9
10