Studio Gt Quick Start; Studio Gt Hook-Up - Samson Studio GT Manual De Instrucciones

Studio GT Quick Start

Studio GT Hook-Up

1. Unpack the Studio GT system components and included cables. Be sure to save
the packaging in case you ever move or need to send the units for service.
2. Set the Studio GT monitors in place near your computer or multi media center.
The active speaker (the one with the front panel controls and jacks) is the right
side speaker and the passive speaker (no knobs and jacks) is the left-side speaker.
3. Connect the left and right speaker using the included speaker cable.
4. Plug the included power cable into the AC IN jack.
5. Connect the USB cable from the right speaker to an available USB port on your
computer.
6. Power on your Studio GT system using the rear panel POWER switch, but keep the
volume all the way down to start.
7. Make sure your computer Output Volume is set to maximum.
8. Run an audio signal through your Studio GT monitors and raise the Level control
to a comfortable listening level.
Owner's Manual
Studio GT Quick Start
Studio GT
11