Windows Xp - Samson Studio GT Manual De Instrucciones

Installing the Studio GT

Windows XP

The Studio GT does not require any
special drivers or software. Just plug in
the Studio GT into a USB port on your
computer and everything is installed
automatically.
1. The first time you plug the Studio
GT into a USB port, Windows XP will
install the universal drivers for that
port. A balloon tip will pop up, telling
you it has found the Samson StudioGT
(Figure 6).
2. When it is finished installing the driv-
ers, it will say "Your new hardware is
installed and ready to use" (Figure 7).
Note: This balloon will not pop up
again for the same USB port.
3. You will then set the Studio GT as your
SOUND PLAYBACK and SOUND RE-
CORDING default device in Sound and
Audio Devices Properties in Control
Panel (Figure 8).
4. Set the output volume by clicking the
speaker icon in the bottom right hand
corner (Figure 9).
20
Studio GT
Figure 6
Figure 7
Figure 8
Figure 9