Troy-Bilt 020210 Manual Del Operador página 12

Ocultar thumbs Ver también para 020210:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Section 4: Operation
Now to Use the SprayT[ps
The qock-connect
on the nozzle extension
allows you to
switch between
five different
spray tips.The
spray rips vary
the spray pattern
as shown
below
(Rgure
[[).
CAUTION
1
NEVER exchange spray tips without engagingthe trigger Hock
on the spray gun trigger,
Follow
these
instructions
to change
spray tips:
[.
Engage trigger lock on spray gun.
2.
Pu[[ back co[Jar on qock-connect
and pu[[ current
spray tip off. Store
spray tips in space provided
on
handle storage pane[.
3.
Select desired
spray alp:
For gende
rinse, seHect white 40 ° or green 25 °
spray alp.
To scour surface_ select yellow
[5 ° or red 0° spray
tip.
To apply chemical
select black spray tip.
4.
Pull back on collar, insert new spray tip and release collar.
Tug on spray tip to make sure it is securely in place.
5.
For most effective
cleaning, keep spray tip from 8 to 24
inches away from cleaning surface.
If you get spray tip
too close, you may damage cleaning surface.
6.
DO NOT get closer than 6 inches when
cleaning tires.
Cleaning[
and
Chemical
[NPORTANT:
Use soaps designed
spec[_ca[[y for
pressure
washers.
Household
detergents could damage
the pump.
• Starting the engine without all the hoses connected
and
without the water turned ON wil[ damage the pump.
Damage to equipment resulting from failure to follow this
instruction will void warranty:
To apply
detergent
follow
these
steps:
I.
Review spray tip use.
2.
Prepare
detergent
solution as required
by manufacturer.
3.
Place chemical
injection
siphon/filter
into detergent
container.
When inserting the fiJter into a detergent solution horde,
rotate the tube so as to keep it from inadvertently contacting
the hot muffler:
4.
Hake sure black spray tip is installed.
NOTE:
Detergent
cannot
be applied
with the high
pressure
spray tips (White,
Green,Yellow,
or Red).
5.
Make sure garden
hose is connected
to water
inlet.
Check that high pressure
hose is connected
to spray
gun and pump; start engine.
Low
Pressure
Use to apply
chemical
Black
White
40 °
Green
Yellow
25 °
15°
i
Red
0 o

Publicidad

Tabla de contenido
loading

Tabla de contenido