Pump Maintenance - Troy-Bilt 020210 Manual Del Operador

Section 5: Maintenance
Pump Maintenance
Changing Pump oim
Change @i after first 50 hours of operation and then every
200 hours or 3 months_ whichever occurs first,
NOTE:When changing pump oil use oniy high quality
nondetergent 30 weight oil Use no spedai additives.
Change pump oim as fommows:
i. Ciean area around brass @i drain piug at bottom of
pump.
2. Remove oii drain piug. Drain oii compieteiy into an
approved container.
3. When oii has compieteiy drained, instali oii drain piug
and tighten firmiy.
4. Ciean area around pump oii dipstick. Remove dipstick
and firthpump with recommended oii to "Furore"mark on
dipstick (typicaliy 0.43L or i5 oz.).
5. Instali pump oii dipstick.
6. Wipe up any spilled oil
D ata Tag
Data tag information is very important if you need help from
our Customer Service Department or an authorized service
dealen
o The data tag (Figure I5) is located on the base of the
pressure washer. For future reference, please copy the
model, revision, and serial number of the pressure washer
in the space below.
MODEL 1
REV NO I
SERIAL I
PSi i
GPM I
Copy Model
}'_"_'_ Number Here
]_ _Copy Revision
Here
Copy Serial
Number Here
I
]