Cleaning Detergent Siphoningtube - Troy-Bilt 020210 Manual Del Operador

Section 4: Opecation
6. AppHy detergent to a dry surface, starting at Hower
portion of area to be washed and work upward_ using
long, even, overlapping strokes. DO NOT aHHow
detergent to dry on (prevents streaking).
7. AHHowdetergent to soak in between 3-5 minutes
before washing and rinsing. ReappHyas needed to
prevent surface from drying.
mMPORTANT:You must flush the chemicaH iniection
system after each use by pHacing the filter into a bucket of
dean water, then run the pressure washer in How pressure
for H°2 minutes.
PressHre Washer Rinsing
After you have
appmied
de{:ergen{:, scour {:he surface
and rinse i{: dean as fommows:
H. Engage safety Hatch on spray gun.
2. Remove bHack chemicaH spray tip from nozzHe
extension.
3. SeHectand instaHH desired high pressure spray tip
following instructions in "How to Use Spray Tips'.
4. Keep spray gun a safe distance from the area you pHan
to spray.
WARNING
Keep spray nozzle between 8 to 24 inches away from cleaning
surface.
Operate this unit on a stable surface.
Be extremely careful if you must use the pressure washer from
a ladder; scaffolding or any other relatively unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid iniury if gun kicks back.
S. Increase (decrease) spray pressure by turning pressure
controH knob cHockwise (countercHockwise) (See
"KnowYour Pressure Washer"). Use lower pressure to
wash items such as a car or boat. Use higher pressure
to strip paint and degrease driveways.
6. AppHy high pressure spray to smaHH area and check
surface for damage. If no damage is found, you can
assume it is okay to continue cHeaning.
7. Start at top of area to be rinsed, working down with
same overHapping strokes as you used for cHeaning.
Cleaning Detergent SiphoningTube
If you used the detergent siphoning tube,you must flush it
with dean water before stopping the engine.
H. PHace chemicaH iniection siphon/fiHter in a bucket fuHH of
dean water.
2. Engage trigger Hock on spray gun.
3. Attach bHack cHeaning detergent nozzHe.
4. Hush for H°2 minutes.
5. Shut off engine.
6. ALWAYS point gun in a safe direction and squeeze
spray gun trigger to reHease retained high water
pressure.
iMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
AHtomatic Cool Down System
(Thermam Remief)
If you run the engine on your pressure washer for
3=5 minutes without pressing the trigger on the spray gun,
circuHating water in the pump can reach temperatures
above H25°F.The system engages to cooH the pump by
discharging {:he warm water on{:o {:he ground.