Troy-Bilt 020210 Manual Del Operador página 7

ASSEMBLY
mMPORTANT: Read entire operator's manuaH beforeyou
attempt to assembHeor operate your new pressure washen
Remove Pressure 4asher From
Carton
H. Remove high pressure hose_ handHe_and parts box
incHuded with pressure washer.
2. SHicetwo corners at end of carton from top to bottom
so paneH can be folded down flat_ then remove aHH
pacHdng material
3. RoHH pressurewasher out of carton.
Carton Contents
[terns in the carton include:
Main unit
High pressure hose
Spray gun with qock connect fitthlg
Nozzle extension with qock connect fitting
HandHe
Engine oil
Safety goggles
Parts Bag (incHudes the foHHowing):
Owner's registration card
Bag containing 5 muHti-coHored quick connect
spray tips
Operator's manual
Engine operator's manuaH
Emissions control warranty sheet
HandHe Fastening Hardware Kit (which incHudes):
Carriage BoHts (2)
PHastic Knobs (2)
If any of the above parts are missing or damaged, caHH the
pressure washer he[p[ine at [ -888-6 [ [ -6708.
PREPARING PRESSURE
WASHER FOR USE
If you have any probHems with the assembHy of your
pressure washer or if parts are missing or damage& caHH the
pressure washer heHpHine at i -888-6 i i -6708.
To prepare
your
pressure washer
for operation, you
will need to perform these tasks:
H. Firthout and send in registration card.
2. Verify oiH dipstick has been installed into pump (Figure H).
3. Attach handle to main unit.
4. Add oiH to engine.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Connect nozzHe extension to spray gun.
9. SeHectand instaHH desired quick connect spray tip.
O