Ninja BL820 Guia Del Usuario página 15

Assembly and Use of the Nutri Ninja
WARNING: Handle the Nutri Ninja Blades
WARNING: Remove utensils prior to processing. Failure to remove may cause the Nutri Ninja cup to be
damaged or to shatter, which may cause personal injury.
WARNING: Never leave the appliance unattended while in use.
CAUTION: Do not blend hot liquids, doing so may cause excessive pressure buildup, resulting in risk of
the user being burned.
CAUTION: Remove the Nutri Ninja Blades Assembly from the Nutri Ninja cup upon completion of
blending. Do not store ingredients before or after blending them in the cup with the blade assembly
attached. Some foods may contain active ingredients or release gases that will expand if left in a
sealed container, resulting in excessive pressure buildup that can pose a risk of injury. For ingredient
storage in the cup, use only Sip & Seal
IMPORTANT: Make sure that the motor base is plugged in for use.
ASSEMBLY
Fig. 9 Fig. 10
1 Review warning and caution statements above
before proceeding to number 2.
2 Place the motor base on a clean, dry, level surface
such as a counter or table top.
3 Add ingredients to the Nutri Ninja cup.
NOTE: Do not overfill! To avoid spilling, do not
add ingredients past the "Max" fill line.
4 Place the Nutri Ninja Blade Assembly onto the cup
and tightly screw it on clockwise until you have a
good seal. (Fig. 9)
5 Turn the Nutri Ninja cup upside down and place it
onto the motor base, aligning the tabs on the cup
with the motor base. (Fig. 10) Turn clockwise until
the cup locks in place, the unit is ready for use.
(Fig. 11)
6 The Nutri Ninja cup only operates at one speed
regardless of which number is chosen on the dial.
Assembly with care, as the blades are sharp.
®
Lid to cover.
®
PULSE
Fig. 11
For best results, use short "PULSES"... Practice makes perfect!!
Cup
®
REMOVAL
Fig. 12 Fig. 13
Press down on the "Start/Stop/Pulse" toggle in
short intervals until you have reached your desired
consistency. (Fig. 11)
7 When you have reached your desired consistency,
turn the Nutri Ninja cup counter clockwise
(Fig. 12) and pull straight up to remove. (Fig. 13)
8 Turn the cup upright and remove the Nutri Ninja
Blade Assembly by twisting the blade assembly
counter clockwise. (Fig. 14)
9 Do not store blended contents with the Nutri Ninja
Blade Assembly attached.
10 Place the Sip & Seal
twist on to seal and enjoy!
11 For storage, only use Sip & Seal
12 Be sure to store the Nutri Ninja Blade Assembly
attached to an empty cup when not in use.
13 Make sure that the motor base is unplugged when
not in use.
www.ninjakitchen.com
Fig. 14
lid onto the Nutri Ninja cup,
®
lid to cover.
®
15