Ninja BL820 Guia Del Usuario página 17

USE
CHOPPING BLADE
ASSEMBLY
Fig. 20
USING THE CHOPPING BLADE ASSEMBLY
1 Review warning and caution statements at the top of
page 16 before proceeding to number 2.
2 Place the motor base on a clean, dry, level surface
such as a counter or table top. (Fig. 23)
3 Secure the bowl onto the motor base.
4 Holding the Chopping Blade Assembly by the shaft,
place it onto the star-shaped post inside the bowl.
Ensure that the Chopping Blade Assembly fits on the
star-shaped post and that it is standing straight.
5 Add the ingredients and secure the bowl lid onto the
bowl. (Fig. 20)
6 Plug the power cord into the electrical outlet and
press the power toggle up ( ) to turn the power
"On".
7 Select the speed that best suits your needs. Pulse
ingredients for even chopping by pressing down
on the "Start/Stop/Pulse" toggle in short intervals.
Press up on the "Start/Stop/Pulse" toggle to run the
unit continuously.
NOTE: When making dips or sauces, set the variable
speed on a low setting (1-3) and press the "Start/
Stop/Pulse" toggle up.
NOTE: Please refer to "Speed Settings & Uses" chart
for suggested uses and speeds.
8 When you have reached your desired consistency,
stop the appliance by pressing the "Start/Stop/
Pulse" toggle up and wait for the Chopping Blade
Assembly to stop turning.
9 Press the power toggle ( ) down to turn the power
off.
10 To remove the lid, press the release button and turn
the lid counter-clockwise and lift the lid off. Hold the
bowl with one hand and lift the lid with the other for
best leverage. Turn the bowl counter-clockwise and
then lift off the base. (Fig. 21, Fig. 22)
REMOVAL
Fig. 21 Fig. 22
1 Review warning and caution statements at the top of
2 Place the motor base on a clean, dry, level surface
3 Secure the bowl onto the motor base.
4 Holding the Dough Blade Assembly by the shaft,
5 Add the ingredients and secure the bowl lid onto
6 Plug the power cord into the electrical outlet and
7 IMPORTANT: Use only the "DOUGH/DISC" setting
8 When finished making dough, press up on the
9 Press the power toggle ( ) down to turn off the
USING THE DOUGH BLADE ASSEMBLY
page 16 before proceeding to number 2.
such as a counter or table top. (Fig. 23)
place it onto the star-shaped post inside the bowl.
Ensure that the Dough Blade Assembly fits on the
star-shaped post and that it is standing straight.
the bowl.
NOTE: For best results add dry ingredients first and
then add wet ingredients.
press up on the power toggle ( ) to turn the power
"On".
when mixing dough or using either disc. Press up
on the Start/Stop/Pulse Toggle to start the unit.
Start/Stop/Pulse Toggle to stop the unit. Remove
the bowl from the motor base. (Fig. 21, Fig. 22)
unit.
NOTE: As a safety feature, the power light
will flash when the power toggle ( ) is pushed
upwards if the lid or bowl are not installed
correctly. Then the lid and bowl are installed
properly and the toggle ( ) is pushed up, the
power light will become solid, indicating the
unit is ready for use.
www.ninjakitchen.com
USE
DOUGH BLADE
ASSEMBLY
Fig. 23
17