5. Room temperature sensor: NTC probe for measuring the
ambient temperature of the room.
6. Water inlet temperature sensor
7. Hydraulic connections: ½ female type water inlet and outlet
sockets with twin and symmetrical type steam bleeders.
B.
VARESE / VARESE LP
1. Exterior casing: in galvanized sheet steel, painted with high
durability epoxy-polyester type paint, with removable front grille
and high strength. Exit holes for electro thermostatic valves and
/ or pre-drilled hydraulic taps.
2. Heat exchanger: Exchanger with corrugated aluminium fins and
expanded copper pipes, 2 ranges and 4 rows. Reversible for
right or Reversible left-hand side connection.
3. Trim
4. Hydraulic connections: ½ female type water inlet and outlet
sockets with twin and symmetrical type bleeders.
EN
20
GENERAL CHARACTERISTICS
3.
The VARESE emitters are suitable for one-pipe and two-pipe
heating installations, in new constructions or the replacement of
previously installed radiators, with possibility of right or left-hand side
connection.
Examples of one- and two-pipe installation are below. In all of them
the option for connection on the right hand is shown, but all can be
carried out with left-hand connections without changing the model.
*NOTE: All valves, fi ttings, pipes, ducts etc. shown
are not supplied in any context by VARESE range
suppliers.
3.1
Suitable for right or left-hand side connection. Exposed valves. The
use of valves with curve for water inlet at the upper outlet.
cod. A73022041
TYPES OF INSTALLATION SUPPORTED
ONE-PIPE INSTALLATIONS