English; Introduction; Installation; Rear Panel - Platec Beast 250E Manual De Instrucciones

GB
8

ENGLISH

7

INTRODUCTION

250E is an inverter power source that can carry out the
following welding modes:
• M
MA
• T P
IG ULSATO
• T C L
IG ONTINUO IFT
The generator has:
A front control panel with socket for remote controls.
A rear panel with switch and supply cable.
On the front: a positive (+) welding socket and a negative
(-) welding socket.
VENTILATOR. The ventilator is turned on only during the
welding phase, at the end of this phase it remains turned
on for a pre-established period of time according to the
welding conditions. However, the ventilator is checked by
special thermal sensors that guarantee the correct
cooling of the machine.
THE MACHINE CAN ALSO BE CONNECTED TO
ENGINE-DRIVEN GENERATORS AS LONG AS THEY
HAVE A STABILIZED VOLTAGE.
8

INSTALLATION

WARNING: This equipment does not comply with IEC
61000-3-12. If it is connected to a public low voltage
system, it is the responsibility of the installer or user of
the equipment to ensure, by consultation with the
distribution network operator if necessary, that the
equipment may be connected.
The generator in question must be supplied with a rated
voltage of 3X400V~±15%/50-60HZ.
Connect the generator to the mains supply and position
the switch to the "I"/"ON" position, and the welding
machine will set itself into the last welding process used.
Using the front panel, choose the new welding process.
9

REAR PANEL

I. 4
• C1: Supply cable 4x2,5mm² with a length of 3,5m.
• I1: Supply switch. It is the switch to turn on the
machine. It has two positions, "I"/"ON" and "O"/"OFF".
When the machine is connected to the mains with the
supply switch in the "I"/"ON" position and in the MMA
mode there is power between the negative and positive
clamps.
250E
Cod.006.0001.0159_INVERTER_250E_2.2_17/11/2010_page_8_of_32
In the TIG mode to be able to start the welding process, it
needs the command from the torch button or from the
pedal.
10

FRONT OUTLETS

I. 5
• P1: NEGATIVE (-) welding socket.
• P2: POSITIVE (+) welding socket.