Technical Data; Power Requirements - Truper ROTI-18A2 Instructivo

Technical Data

Code
Description
Chuck
Voltage
Speed
Rotation
Torque
Boring capacity
Insulation
Battery
Charger
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
WARNING Before gaining access to the terminals all power sources should be disconnected.

Power Requirements

WARNING Tools with double insulation and reinforced insulation are equipped with
a polarized plug (one prong is wider than the other). This plug will only fit in the right way
into a polarized outlet. If the plug cannot be introduced into the outlet, reverse the plug. If
it still doesn't fit, call a qualified electrician to install for you a polarized outlet. Do not alter
the plug in any way. Both insulation types eliminate the need of both a grounded third
power cord with three prongs or a grounded power connection.
WARNING
When using an extension cable, verify the gauge is enough for
the power that your product needs. A lower gauge cable will cause voltage drop in the line, resulting in power loss and
overheating. The following table shows the right size to use depending on cable's length and the ampere capability shown in
the tool's nameplate. When in doubt use the next higher gauge.
Ampere
Capacity
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
WARNING When operating power tools outdoors, use a
extension cable labeled "For Outdoors Use". These extensions are especially designed
for operating outdoors and reduce the risk of electric shock.
Position 1:
Position 2:
Class II
Ion-Lithium 18 V
Input:
Power Cord Grips of the charger used in this product: Type "Y".
Number of
Conductors
3 (one grounded)
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE-2006
ROTI-18A2
18155
Cordless hammer drill / drill / driver
1/2" keyless
18 V
0 - 350 RPM y
0 - 1 400 RPM y
Forward - Reverse
18 + 2 functions
Concrete: 0.5" | Wood: 1" | Metal: 0.5"
IP Grade
1,5 Ah | Charging time: 60 min approximately
Voltage: 120 V
Output: 12 V
Frequency: 60 Hz
Power: 40 W
Charger Build Quality: Reinforced Insulation.
Extension gauge
from 5.9' to 49.2'
18 AWG( * )
16 AWG
14 AWG
8 AWG
grounded
0 - 5 600 strokes per minute
0 - 22 400 strokes per minute
IP20
- 21 V
Authorized Service Center.
| higher than 49.2'
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
1,5 A
3