Parts; Start Up; Battery Charge - Truper ROTI-18A2 Instructivo

The wireless hammer drill is
useful to both boring orifices
with the impact mode as well as
screwing and unscrewing.
Double
tip
Battery
charger

Battery charge

1. Plug in the charger in a 120 V~power outlet. (Green
charging indicator light will turn on).
2. Insert the battery into the charger sliding it as shown in
the figure. The green light will turn off and the red light
should be on indicating the charge has initiated.
• When the battery is completely charged, the green light
will be on and the red light will be off.
• Disconnect the charger from the power once the charge
is completed.
• If the red light is blinking it signals a defective battery.
Replace with a new one.
• In case the green light is blinking it signal the
temperature in the battery is lower to 32 °F or higher than
113 °F Wait until the battery temperature is in the
adequate level to be able to charge it.
6
ENGLISH
Keyless
chuck
Battery
level
indicator
LED
light
Rotation direction
button
and switch lock
Charge
Battery
indicator
connection
teeth

Parts

Torque
Speed
regulator
selector
Switch
Battery
release
button
Battery Belt clip

Start Up

2
Handle
1