Toolland TM82007 Manual Del Usuario página 5

4. Overview
Refer to the illustrations on page 2 of this manual.
quick-release lever
1
on-off switch
2
handle connection
3
clamp
4
Accessories
scraper
a
cutting blade
b
sanding base
c
5. Operation
Before using the device, inspect it and its accessories to ensure there is no
5.1 Fitting an Accessory
1. Lift the quick-release lever and push forward to disengage the mounting flange.
2. Fit an accessory under the flange. Ensure the correct orientation of the accessory, so it sits within the
location pins on the flange.
3. Push the quick-release lever backward to the previous closed position. Ensure the blade is securely
fastened.
This multi tool can fit quick-release accessories. If a quick-release accessory needs
Mount bent or cranked blades or scrapers so that the end of the blade sits facing
5.2 Bracket of the Quick-Release Lever
The main function of the bracket [a] is to avoid damage when the user is fitting or changing accessories.
1. Left the quick-release lever and push forward.
2. The bracket jumps up to support the quick-release lever.
3. After fitting the accessory, push the bracket and quick-release lever backward to their previous position.
V. 01 – 23/01/2017
WARNING
excessive wear.
WARNING
to be fitted, the washer must be fitted on the accessory.
away from the tool.
TM82007
variable speed dial
5
LED
6
dust tube
7
sanding paper
d
washer
e
NOTE
5 ©Velleman nv