Preparing The Remote Control; Power On And Setup - Philips NeoPix Easy 2+ Manual Del Usuario

Preparing the remote
control
CAUTION!
The improper use of batteries can
lead to overheating, explosion, risk of
fire and injury. Leaking batteries can
possibly damage the remote control.
Never expose the remote control to
direct sunlight.
Avoid deforming, dismantling or
charging the batteries.
Avoid exposure to open fire and water.
Replace empty batteries immediately.
Remove the batteries from the remote
control if not in use for long periods of
time.
1 Open the battery compartment.
2 Insert the supplied batteries (type AAA)
with correct polarity (+/- ) indicated.
3 Close the battery compartment.
• When using the remote control, point
the remote control at the IR sensor on
the projector, and make sure there is no
obstacle between the remote control and
the IR sensor.

Power on and setup

1 Press to turn on the projector. The LED
on the projector turns from red to green.
• To turn off the projector, press
The LED on the projector turns from
green to red.
• The distance between the projector and
the screen determines the actual size of
the image.
Initial operation
2 To adjust the screen height when placing
the projector on the table, turn the angle
adjustment knob located on the bottom of
the projector.
3 To adjust image focus, turn the focus knob
on the top of the projector.
NeoPix
Easy 2 +
4 To correct keystone or distorted images to
be rectangular or square, press
SETUP - Keystone Correction . Then press
/ to adjust the image shape.
5 To adjust image size, press
SETUP - Digital Zoom . Then press / to
adjust the image size.
again.
AUX MICRO SD HDMI USB DC
and go to
and go to
9