Hart HPBF01 20V Manual Del Operador página 5

ASSEMBLY
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-776-5191 for assistance.
OPERATION
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Polishing and buffing cars, boats, RVs, personal
watercraft, motorcycles, hardwood floors, and large
furniture
TURNING THE BUFFER/POLISHER ON/OFF
See Figure 1, page 10.
 To start the buffer/polisher, place the power switch in the
ON ( l ) position.
 To stop the buffer/polisher, place the power switch in the
OFF ( O ) position.
The tool's rotating base moves in random orbital motion.
The orbit diameter is 1/2 in.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
Battery tools are always in operating condition.
Therefore, the switch should always be in the OFF
(O) position when not in use or carrying at your side,
when installing or removing the battery pack, and when
installing or removing accessories.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 10.
Make sure the ON/OFF switch is in the OFF ( O ) position.

Insert the battery pack into the battery port as shown.

Make sure the latch on the battery pack snaps into place

and the battery pack is secured in the product before
beginning operation.
Put the switch in the OFF ( O ) position and depress the

latch, then pull to release and remove the battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
PREPARE THE SURFACE
For best results, the surface should be clean and dry. Most
high-gloss surfaces can be cleaned with a mild soap and
water solution. For removal of stubborn dirt such as road
tar, grease, and bug stains, you can use a mild ammonia
solution such as that used in glass cleaners. Before using
any cleaning product, check the label for recommended
applications and follow the directions for use.
Never apply cleaner directly onto surface to be polished.
Apply to a clean cloth then use the cloth to clean the surface.
Do not use any type of abrasive cleanser as it may damage
or scratch the surface.
5 – English