dirna Bergstrom bycool blue line Scania NTG FLAT Instrucciones De Montaje página 25

FLAT
Operations to be carried out
to assemble water tank:
20
Position tank support on lower part of rear cabin
area, where it is most adequate.
21
Mark and drill cabin at Ø 9, taking into account
vertical position of support. Minimum of 6 holes to
fasten.
22 Place M6 riveting nuts and fasten support using
6/100x30 screws.
(*) - in case it does not rest on smooth part, place
10mm.separator and 6/100x40.
Rivet nut M6
25
6/100x30 allen
Grower washer Ø 6
Flat washer Ø 6
(4) Supports
Tank
6/100x30
Grower washer Ø6
Flat washer Ø8
Support
Rear part cab
(*)
6/100x40
(*)
10 mm separator
(*)
Rear part cab
EN
®