Electrical Connection; Door Reversibility - Electrolux END 32321 X Manual De Instrucciones

20 electrolux

Electrical connection

Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to your
domestic power supply. Voltage can
vary by ±6% of the rated voltage.
For operation with different voltages, a
suitably sized auto-transformer must
be used.
The a a ppliance m m ust b b e e e arthed.
The power supply cable plug is
provided with a contact for this
purpose.
If the domestic power supply socket is
not earthed, connect the appliance to
a separate earth in compliance with
current regulations, consulting a
specialist technician.
The M M anufacturer d d eclines a a ll
responsibility i i f t t he a a bove s s afety
precautions a a re n n ot o o bserved.
This appliance complies with
the following E.E.C. Directives:
87/308 E E EC of 2/6/87 relative to
•
radio interference suppression.
• 73/23 E E EC of 19.2.73 (Low Voltage
Directive) and subsequent
modifications;
• 89/336 E E EC of 3.5.89
(Electromagnetic Compatibility
Directive) and subsequent
modifications.

Door reversibility

Before carrying out any operations,
remove the plug from the power
socket.
To change the opening direction of the
door, proceed as follows:
- To carry out the following
operations, we suggest that this be
made with another person that will
keep a firm hold on the doors of
the appliance during the operations.
- Open the door with the appliance in
the upright position. Unscrew the
screws and remove the upper door
plastic trim.
- Remove the little plastic cover from
the door plastic trim and refit on the
opposite side (d).
- Lay down the appliance back side
down.
- Remove the plastic hinge covers dx
and sx (3).
- Unscrew the upper hinge and
remove it (1-2)
- Unscrew the screw and remove the
door stopper (4).