Peg-Perego tender csr Instrucciones De Uso página 11

PERFORMED BY AN ADULT.
• DO NOT LIFT THE STROLLER BY
GRIPPING THE FRONT BAR. THE
FRONT BAR IS NOT DESIGNED TO
WITHSTAND LOADS.
• ENSURE THAT THE STROLLER IS
OPENED CORRECTLY AND LOCKED
IN POSITION OF USE.
• CHECK TO MAKE SURE THAT THE
CAR SEAT OR THE BABY CARRIAGE
IS CORRECTLY FASTENED TO THE
STROLLER (WHERE APPLICABLE).
• DO NOT DRIVE THIS PRODUCT
AROUND STAIRS OR STEPS; CARE
MUST BE TAKEN IF UNIT IS USED ON
STAIRS OR ESCALATORS.
• DO NOT USE THE PRODUCT IF IT
HAS BROKEN OR MISSING PARTS.
• DO NOT USE NEAR FIRE OR
EXPOSED FLAME.
• NOTICE: THIS ARTICLE MEETS OR
EXCEEDS ALL REQUIREMENTS
COVERED IN ASTM F833 STANDARD
AND LATEST REVISIONS.
instructions for use
OPENING
1• To open the Tender CRS stroller, release the
safety hooks from inside the handlebar to
unlock the stroller, as indicated in the fi gure.
2• Lift the handlebar up following the direction of
the arrow and lock it at the last click.
3• Make sure that it is opened correctly by
checking that the side hooks are properly
fastened, as indicated in the fi gure.
MOUNTING THE WHEELS
4• Insert the rear wheels as shown in the fi gure
until you hear a click.
5• To insert the front wheels, lower lever A and
then slide the wheel on as shown in the fi gure
until you hear a click.
DRINK-HOLDER
6• The drink holder can be placed on the left or
right hand side of the stroller, thanks to the
attachment which is already fi tted on both
sides. To fi t the drink holder, click it on, as in
Figure A. See Figure B for a fi tted drink holder.
Do not put hot drinks in the drink-holder,
nor items weighing more than 0,5 kg (1 lbs).
HOODS
7• The hoods are independent and you can
decide whether you want to mount one or
both. Before mounting the hoods, check the
inside label, which distinguishes the rear hood
(larger) from the front one (smaller). Insert the
hood fi ttings in the housings, as shown in the
fi gure.
8• Button the hoods to the rear of the backrests,
lower the dividers to tighten them and fasten
the buttons on the lowest part of the hoods to
the sides, as indicated in the fi gure.
9• To remove the hoods, pull the attachments
upwards, unbutton them from the backrests
and the sides and then press on both sides of
each hood to unfasten them, as indicated in
the fi gure.
10• The hoods can be transformed into sun
canopies by unzipping them, as shown in the
fi gure.
BASKET
11• The stroller has two baskets (identical). To hook
the basket to the front of the stroller, slide the
slot in the button as shown in the fi gure; then
slide the tongue behind the bar as shown in
the fi gure and button.
12• The fi gure shows the basket hooked to the
front of the stroller.
13• To hook the basket to the rear of the stroller,
slide the slot in the button as shown in the
fi gure; then slide the tongue behind the bar as
shown in the fi gure and button.
14• The fi gure shows the basket hooked to the rear
of the stroller.
SAFETY BELT
15• A: Make sure that the brace is properly inserted
by pushing as shown in the fi gure. B: Fasten the
belt as shown in the fi gure.
16• To unfasten the belt, press on the buckle sides
and pull out the waist strap.
17• The new safety belt is now easier to fasten
thanks to the "snap-open-and-shut" device.
Before fastening the safety belt, attach the
buckle to the backrest by inserting the tab
through the special holder, as shown in the
fi gure. After fastening the safety belt on your
child, detach it from the backrest to allow the
child more freedom of movement. The buckle
must remain below the child's shoulders.
BRAKE
18• Do not brake when going uphill, because this
can make the stroller unstable. To brake the
stroller, use your foot to press on the braking
bar located on the rear wheels (to release the
brake, do the opposite).
SWIVELLING WHEELS
19• To make the front wheels swivel, you must
lower the lever, as shown in the fi gure. To
make them fi xed, turn the lever in the opposite
direction.