Connect The Drain Hose - Magic Chef MCSTCW16W4 Manual Del Usuario

4� Run water through the hoses for 10-15 seconds, allowing it to
drain into a bucket or sink to remove any foreign substances
from the lines, then turn off the water�
5� Connect the ends of the water supply hoses to the water
supply intake connections at the back of the washer�
NOTE: The water supply hose connected to the HOT faucet must be connected to the hot water supply
intake and the water hose connected to the COLD faucet must be connected to the cold water supply intake�
6� Tighten the fittings by hand until they are snug, and then tighten them an additional two-thirds of a turn
with a wrench� Turn on the water and check for any leaks�
WARNING: Confirm that the water supply hoses are not twisted or bent� If the hoses are twisted or
bent, the hoses can leak and cause electric shock due to the water leakage �To ensure the correct water
usage, connect both the HOT and COLD water faucets� If either or both are not connected, an error code
can occur� If you do not want to use the HOT water supply hose or can only connect to one faucet, install
the water intake cap into the HOT water supply intake hole� In this case, you must select Cold water as the
wash temperature choice�

CONNECT THE DRAIN HOSE

Position the other end of the drain hose� It can be
positioned in three ways� The recommended height of the
drain hose is 35" (90cm), and should be no higher than 39"�
The washer should be located within 5' of the drain�
a� Over the edge of a sink: Secure the guide to the side
of the basin wall with a hook or to the tap with a
piece of string or zip tie to prevent the drain hose
from moving�
b� In a standpipe: The standpipe must be no shorter than
32 in� (81cm) and no longer than 39 in� (100cm)� The
diameter of the drain pipe must be large enough to
easily accept the drain hose�
c� In a laundry tub: The laundry tub must be no shorter than 32 in� (81cm) and no higher than 39 in� (100cm)�
NOTE: The connection between the drain hose and sink, pipe, or tub should not be airtight�
RUN A TEST CYCLE
1� Plug in the washer�
2� Load about 5 lbs� of laundry�
3� Press the "Power" button to turn on the washer�
4� Select the "Rinse & Spin" cycle by pressing the "Function" button to turn on the indicator lights for "Rinse"
and "Spin", and then press the "Start/Pause" button�
5� The washer should not rock or vibrate excessively when water is supplied or when washing or spinning, and
should drain well during the spin cycle�
NOTE: If water leaks while water is being supplied or drained, check the water connections� If the washer rocks
and vibrates excessively, level your washer again�
a
c
10
Figure 11
Figure 12
b