Haier HOA-P10PW4X Manual De Uso página 53

OPERATION
Turn on the oven and set the time.
When you plug in the appliance there is a
[confirmation] beep. Set the current time. The
current time must be set for the appliance
to operate. Touch controls or knobs do not
respond. An [error] beep is emitted. You can
only set the current time
The clock shows 24-hour or AM/PM time.
Touch and hold
time. You will hear the [confirmation 2] beep
and "24 h" or "12 h" will flash on the display.
Use the setting selection knob to change
the time mode. Touch [ ] briefly to confirm.
Hour digits will start to flash. Use the set-
ting selection knob to set the hour 00–23
(or 01–12 AM, 01–12 PM depending on time
mode). The hour digits stop flashing. Touch
briefly to confirm. A [confirmation] beep is
emitted. The minutes digits start to flash and
you can now set the minute. Use the setting
selection knob to set the minute. Touch
to confirm. An [end] beep is emitted. Digits
are not flashing and the clock shows current
time. The second indication colon is flashing.
If you do nothing for 5 seconds when setting
the time, the [settings entered] beep is emit-
ted. The clock will be set to the last setting
entered by the user. The oven enters the
standby mode. You can use oven functions.
.
for 3 seconds to set the
In standby mode, the display intensity set to
low. The following are displayed:
l clock,
l symbols of the active functions: oven
cavity residual temperature, child lock,
kitchen timer, door lock.
When you use any controls the appliance
enters the operating mode. Display intensity
is set to high.
To turn off the oven — set function selector
knob to 0.
Important! In the event of a power outage
all set functions, automatic programmes, set
temperatures and timer are cleared. If you
interrupt the pyrolytic cleaning (or the door
is locked for any other reason), the oven will
start the cooling and door opening procedure
before you can set the time.
53