Honeywell Home RCHT8600 Serie Guía De Instalación Rápida página 4

Quick Installation Guide
8
Disconnect the wires and remove the old wall plate.
Use a screwdriver to release wires from terminals. Then, use a wire label to
identify each wire as it's disconnected. The letter on the wire label should match
the letter on the terminal.
Tip: To prevent wires from falling back into the wall, wrap the wires around a
pencil.
Installing your RCHT8600 thermostat
RCHT8600
Thermostat
9
Bundle and insert wires through the UWP.
Pull open the UWP and insert the bundle of
wires through the back of the UWP.
Make sure at least 1/4-inch of each wire
is exposed for easy insertion into the wire
terminals.
UWP
Screws Mounting
System
4
Anchors Wall