Using The Floor Nozzle - Stihl SE 33 Manual De Instrucciones

9 Using the wet/dry vacuum cleaner
Removing the cartridge filter
1
► Rotate the wing screw (1) counterclockwise.
► Remove the cartridge filter (2).
Checking the float
3
► Swing the float back and forth.
The float (3) moves.
► If the float (3) does not moved: Clean float (3) with a soft
brush.
► If the float (3) still does not move: Do not use the wet/dry
vacuum cleaner. Consult a STIHL dealer.
There is a fault in the float (3).
0458-889-9821-A
Placing the foam filter
2
► Push the foam filter element (5) over the motor housing
(4).
► Put the top ini place and fasten the container locks.
► Switch the wet/dry vacuum cleaner on.
► Hold the suction hose in one hand and pick the material
up either directly or via an attached accessory.
► If the suction power deteriorates noticeably: Switch off the
wet/dry vacuum cleaner, pull the mains plug out of the
socket and empty the container.
9.3

Using the Floor Nozzle

1
► To clean carpeted floors, set the rocker switch on the floor
nozzle to position (1).
► To clean hard floors, set the rocker switch on the floor
nozzle to position (2).
English
4
5
2
33