GMC GER1800 Manual De Instrucciones página 11

Ocultar thumbs Ver también para GER1800:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
• To replace the brushes;
1. Face the router down horizontally with the flat edge of the Base Plate (14) at the bottom
2. Remove the Brush Access Screws (21) from the motor cover
3. Gently slide the motor cover off horizontally so the Speed Adjustment Buttons (3) remain in place and do
not fall out
4. Lift the edge of the Carbon Brush Holders up and carefully pull out (Image N) so the notch at the bottom is
clear
5. Disconnect the spade terminal and replace the carbon brushes on both sides
6. Refit into brush housing on both sides, refit motor cover and Brush Access Screws ensuring the Speed
Adjustment Buttons stay in place
• Alternatively, have the machine serviced at an authorised service centre
Note: Always replace carbon brushes in pairs and once fitted the brushes may take a short time to bed in.
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: GMCtools.com/en-GB/Support
Address:
Powerbox
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional and are
not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with household
waste
• Contact your local waste disposal authority for information on the correct way to dispose of power tools
11
GB

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido