Service; Air Source; Unpacking; Contents - Campbell Hausfeld CHN70600 Manual De Instrucciones Y Lista De Piezas

Operating Instructions and Parts Manual
Important Safety Information (Continued)

servICe

a. Tool service must be performed only by qualified repair
personnel.
b. When servicing a tool, use only identical replacement
parts. Use only authorized parts.
c. Use only the lubricants supplied with the tool or specified
by the manufacturer.
Disconnect air supply and release tension
from the pusher before attempting to clear
jams because fasteners can be ejected from the front of the nailer.
Personal injury may occur.

AIr sourCe

a. Never connect to an air source that is capable of exceeding
200 psi. Over pressurizing the tool is able to result in
bursting, abnormal operation, breakage of the tool or
serious injury to persons. Use only clean, dry, regulated
compressed air at the rated pressure or within the rated
pressure range as marked on the tool. Always verify prior to
using the tool that the air source has been adjusted to the
rated air pressure or within the rated air-pressure range.
b. Never use oxygen, carbon dioxide, combustible gases or
any bottled gas as an air source for the tool. Such gases are
capable of explosion and serious injury to persons.
Air compressors providing air to the nailer
should follow the requirements established
by the American National Standards Institute Standard B19.3-1991;
Safety Standard for Compressors for Process Industries. Contact your
air compressor manufacturer for information.
sAve tHese INstruCtIoNs
do Not dIsCArd
The DANGER, WARNING, CAUTION, and NOTICE
notifications and instructions in this manual cannot
cover all possible conditions and situations that may
occur. It must be understood by the operator that
common sense and caution are factors which cannot
be built into this product, but must be supplied by the
operator.

Unpacking

After unpacking the unit, inspect carefully for any damage that
may have occurred during transit. Check for loose, missing
or damaged parts. Make sure to tighten fittings, bolts, etc.,
before putting unit into service. Check to be sure all supplied
accessories are enclosed with the unit. In case of questions,
damaged or missing parts, please call 1-800-543-6400 for
customer assistance.

CoNteNts

Angle Finish Nailer
u
2-1/2 inch Angle Finish Nails
u
Operating Instructions
u
Warranty Card
u
Carry Bag
u

AddItIoNAl IteMs Not INCluded

Compressor (must be able to maintain a minimum of 70 psi
u
when the nailer is being used)
Air hose
u
Small tool for clearing jams
u
Threadlock glue
u
ANSI Z87 eye protection
u
Hearing protection and other personal protective
u
equipment as required

Assembly

This tool comes fully assembled.
CHN70600
7
www.chpower.com