Empty Water Reservoir; Warnings; Maintenance - Qlima H 130 Instrucciones De Uso

Ocultar thumbs Ver también para H 130:

Idiomas disponibles

EMPTY WATER RESERVOIR

The control button will flash for 10 seconds if the water reservoir is empty. Simultaneously

the moisturiser will emit a beep. The moisturiser will automatically turn off. Full the water

reservoir as described in the installation chapter and switch the moisturiser on again.

TAkE CARE

When removing the water reservoir drops of water at the bottom of the reservoir

could cause water damage. Dry the bottom of the water reservoir before moving

it.

TAkE CARE

When removing the water reservoir from the moisturiser all settings will be lost.

1 Never fill the water reservoir with water hotter than 30°C.

2 Never fill the reservoir through the mist nozzle.

3 Ensure that the filler cap of the reservoir is not leaking. Close the filler cap tightly.

4 Ensure that the device and the reservoir are always clean. Remove any dirt before

using the device.

Do not position the outlet of the cold mist nozzle too close to equipment, furniture

etc. to avoid water damage.

6 Check the actual air humidity regularly in the room to prevent any damage to

furniture, equipment etc. from a too high humidity.

Unplug the adapter from the wall socket before carrying out any maintenance, so that the

device is dead.

1 Clean the ultrasonic evaporation element and the water reservoir with a soft cloth.

Then rinse the water reservoir well with tap water and dry the ultrasonic evaporation

element with a soft cloth.

2 Clean the ultrasonic element every time you fill the water reservoir (indicated by

arrow). Carefully remove any calcium and other deposits with the supplied brush.

Tabla de Contenido