Connecting Headphones - OK. OPC 200CD Manual De Instrucciones

EN
PROGRAM
9 Up to 20 tracks can be programmed in a desired sequence.
In stop mode, press the PROG button. 00 flashes.
Select the desired track with the
10
button again. 00 flashes. Select additional tracks with the
PROG.
Start program:
11
MICROPHONE
Switching on: Rotate the MUSIC VOL control in a clockwise direction. The POWER indicator lights
12
up.
Switching on microphone(s): Set the switch to the ON position.
13
Adjusting microphone volume: Rotate the MIC VOL control to the desired volume.
14
Pull one or both of the microphones from their holders and start speaking/singing.
15
Notes:
• Do not hold the microphone too close to your mouth to achieve a clear sound.
• Pointing the microphone towards the appliance or towards each other will lead to sound
distortions.
Switching off microphone(s): Set the switch to the OFF position.
16
SING-ALONG FUNCTION
Switching on: Rotate the MUSIC VOL control in a clockwise direction. The POWER indicator lights
17
up.
Open CD compartment door: Press the OPEN Button. Insert a CD with label facing towards you.
18
Close the CD compartment door.
Start playback:
19
Switching on microphone(s): Set the switch to the ON position.
20
Adjusting microphone volume: Rotate the MIC VOL control to the desired volume. Pull one or
21
both of the microphones from their holders and start speaking/singing to the music of the CD.
Stop playback:
22
Switching off microphone(s): Set the switch to the OFF position.
23

CONNECTING HEADPHONES

Connect headphones with a 3.5 mm plug to the PHONE socket. The loudspeakers are muted
23
whilst the headphones are connected to the appliance.
IM_OPC200CD_140721_V05.indb 16
buttons. Confirm selected track by pressing the PROG
/
Press .
Press .
Press STOP.
16
/ buttons and confirm with
21/7/14 10:02 AM