Atlantic SOLWPL1 Manual Del Producto página 2

Introduction
Thank you for purchasing Atlantic SOL Warm White Pond Lights. Atlantic's Pond Lights feature
high impact cases and silicone gaskets for dependability and longevity. Whether underwater
or in open air applications, SOL Pond Lights impart a soothing, warming glow after the sun
goes down. Available in single light or triple light kits with included removable photo cell
and transformer.
Prior to Operation and Installation
Caution:
• DO NOT operate this product under any conditions other than those for which it is
specified. Failure to observe these precautions can lead to electrical shock, product failure,
or other problems.
• Follow all aspects of electrical codes when installing SOL Lighting.
• To reduce the risk of electrical shock, connect transformer to a 120 volt receptacle protected
by a ground fault circuit interrupter (GFCI).
• Always verify that the lens cover is tightly secured before submersing the fixture
• SOL Warm White Pond lights connect via a 2 wire quick-connect plug that is gasketed for
outdoor use. Quick-connect plugs are not waterproof and should not be submersed.
• Extension cords (part # SOLWEXT) are available to add an additional 20' of cord to any
SOL Light. Only one cord can be used on each light. Never connect multiple extension
cords together.
• Atlantic SOL Warm White lights can be connected to a larger outdoor lighting system with
the quick-connect pigtail (REP SOLPIGTAIL).
Installation
Pond Lights offer two different mounting options for your convenience:
• Adjustable stand: for placement on rock ledges, under waterfalls or for
highlighting streambeds
• Nested: without the stand amongst the pond stones
Proper light placement is important for every project. Whenever possible, lights should be
positioned facing away from the viewing area to minimize hot spots. When camouflaging the
light cord with rocks and gravel, always leave enough slack in the cord so that the fixture can be
raised above water level for servicing.
Maintenance
Replacement LED diode assemblies are available for Pond Lights. Loosen clear plastic lens and
remove diode assembly. Inspect the silicone gasket for defects and proper placement before
re-assembling. Reinstall new diode assembly and align gasket. Tighten clear plastic lens. Ensure
that all components are installed correctly after servicing. Ensure that the clear plastic lens is
tightly secured before submersing the fixture.
Light
Body
2
LED Diode
Silicone Gasket
Assembly
Clear Plastic Lens