Warranty Claims; Troubleshooting Guide - Atlantic SOLWPL1 Manual Del Producto

Winterization
Pond lights may not be left in areas where water freezes solid. If lights are installed in
shallow streambed waters or close to the surface, they should be removed from the pond for
the winter or sunken to deeper areas that do not freeze solid.
Warranty
All Atlantic SOL Warm White Pond Lights carries a one-year limited warranty.
All SOL Wiring Components carry a one-year limited warranty.
This limited warranty is extended solely to the original purchaser commencing from the date
on the original purchase receipt and is void if any of the following apply:
• The light body / LED components have been misused or abused.
• The light body / LED components have been disassembled or modified other than as
described in this manual.
• The light has been damaged by freezing water
This warranty excludes labor / cost of labor for removal or installation of any product.

Warranty Claims

In case of warranty claims, the complete product should be returned to the place of purchase
accompanied by original receipt.

Troubleshooting Guide

Always turn off power before inspecting the SOL lights. Failure to observe this precaution can
result in a serious accident.
Before ordering repairs, carefully read through this instruction booklet. If the problem persists,
contact your dealer.
Problem Possible Cause
No input power to
the transfomer
No outlet power from
the transformer
Lights will
not turn on
Photocell malfunction
Lights will
Photo cell is covered
not turn off
Loose connection
Moisture or corrosion
Individual
in connections
lights within
a larger
system not
Failed LED assembly/
working
lamp
Possible Solution
Verify power to the outlet is on / Check GFCI
reset
Test with multi-tester
Cover the photocell with a piece of dark tape to
check function
Unplug photocell and plug light directly
into transfomer
Clean sensor and outer clear covering
Make sure nothing is shading the sensor
Inspect quick-connected plugs for moisture,
corrosion or missing gasket.
Clean/ dry and reassemble.
If possible, switch out the LED assembly/lamp
with one from a working light of the same model
to determine if the driver has failed.
Replacement LED assembly/lamps
are available.
3