Overview; Design And Function; Main Parts - Chicago Pneumatic CP 0010 Instrucciones De Seguridad Y De Funcionamiento

CP 0010

Overview

To reduce the risk of serious injury or death
to yourself or others, read the Safety
instructions section found on the previous
pages of this manual before operating the
machine.

Design and function

CP 0010 centrifugal pump is intended for pumping
relatively clean liquids such as water and coolants.
It is not recommended to pump any liquid with a
temperature above 212°F (100°C). Do not pump
abrasive liquid. No other use is permitted. CP 0010
is adapted to meet different demands in respect of
flow and pressure head, see diagram below.
CP 0010 is submersible, which means that it can
work fully submersed in the pumped medium. The
impeller of CP 0010 is sand cast in aluminium
bronze, it is driven by an air motor. The compressed
air flows through an air-filter which stops any foreign
matter from entering the pump. The integrated oiler
provides continuous lubrication.
The diagram is valid at 6 bar (87 psi) and when
pumping from base plate level.
H: (m) feet
(35) 115
CP 0010
(30) 98
(25) 82
(20) 66
(15) 49
(10) 33
(5) 16
(0) 0
0 66 132
(0) (5) (10)
Q: gal/min (l/s)
H: Head feet (m)
Q: Flow imp gal/min (l/s)
NOTICE The capacity of the pump will change
and the chart above will not be accurate if a lower
air pressure than the recommended is used, or if the
pumped liquid has a different viscosity than water.
9800 0552 90c | Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
198 264 330
(15) (20) (25)
Safety and operating instructions

Main parts

I
K
A
G
E
A. Shaft seal
Air filter
B.
Motor
C.
D. Filter screen
E. Liquid intake
Discharge outlet
F.
Impeller
G.
Governor
H.
I. Valve
Air inlet
J.
Air outlet
K.
J
B
H
C
F
D
9