Storage - Echo PWE-1800 Manual De Instrucciones

S
toraGe
• DO NOT store the power washer where it is exposed to freezing temperatures unless you use Pump
Saver. It is recommended that you use Pump Saver for storing in freezing temperatures. Freezing will
damage the pump unless Pump Saver is added to the power washer.
• Remove lance from the gun and place in the accessory holder. Place the gun in the accessory holder one
the side. Lances are placed into any of the slots in the back of the unit. Make sure to discard any remaining
detergent from the bottle. Flush the bottle and nozzle head with fresh water to prevent clogging.
• When your pressure washing session has been completed, turn off the power switch located on the front of
the power washer. Unplug the power cord from the outlet. Turn off the water supply. Pull the trigger on the
spray gun 2-3 times to drain out the excess water and to release any remaining water pressure. Disconnect
the garden hose adapter from the water inlet. Do not allow the power washer to run with no water flowing
through it.
• Remove detergent tank and clean completely. Residual chemical will stick to the container and can cause
the detergent injector to clock and not function properly.
• Remove high pressure hose from spray gun and unscrew the other end of the high pressure hose from the
power washer.
• Wrap the power cord around the L-shaped tabs on the right side of the machine when facing it.
• The pressure hose is stored on the hose hook located on the back of the handle.
If not using or if storing your power washer for more than one month, run Pump Saver through it.
See the section on Pump Saver for more information.
16
ECHO PWE-1800 Pressure washer manual 2015.indd 16 2016-04-12 8:26 AM