Kohler Sterling 7610 Serie Manual Del Usuario página 4

8" (203 mm)
4" (102 mm)
Roughing-In
A
76100100 60"
(1524 mm)
60"
76110100
(1524 mm)
IMPORTANT! Dimensions given in the roughing-in information are critical for proper installation.
Construct the framing and plumbing accurately.
IMPORTANT! All dimensions are nominal. The stud opening tolerance is plus 1/8" (3 mm) and minus 0.
IMPORTANT! Unless otherwise specified, the floor support under the whirlpool must provide a minimum
of 80 pounds per square foot (390 kilograms per square meter) loading.
NOTE: If a firewall is required, roughing-in dimensions must be increased according to the thickness of
the firewall material. Stud opening dimensions must be measured toward the exposed side of the wall
material.
NOTE: If installing this unit to a masonry wall, make provisions for plumbing connections. Construct a
separate frame wall at least 6" (152 mm) from the masonry wall.
The whirlpool and optional wall surrounds can be installed directly to the framing studs, over wallboard, or
over other water-resistant material. When installing over wallboard or other water-resistant wall material, the
framing dimensions must be increased to accommodate the material thickness.
For whirlpools with wall surrounds, installing accessories that require backing or support is not
recommended.
1016902-2-F
30" (762 mm)
30" (762 mm)
14" 14"
(356 mm)
(356 mm)
Drain
6"
D
Cutout
(152 mm)
Ø 2" (51 mm)
Drain
B
3-1/2" (89 mm)
A
Recommended Support
Clip Location (4 Total)
Diagrams shown are representative and for use with the table only.
Your fixture may appear different from the illustrations.
B C
8-3/4" 37-1/2"
(222 mm) (953 mm)
8-3/4" 43-1/2"
(222 mm) (1105 mm)
D
F
G
B
C
D E
17-1/4" 73-1/4"
(438 mm) (1861 mm)
20-1/4" 73-1/4"
(514 mm) (1861 mm)
4
A
C
E
F G
8-3/4" 24-1/2"
(222 mm) (622 mm)
11-1/2" 27-1/2"
(292 mm) (699 mm)
Sterling