Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
-
Use medium sanding paper (grain 80) for
removing the remaining scratches from the
coarse sanding paper.
-
Use fine sanding paper (grain 120) for
finishing surfaces.
Removing
•
Place the machine on a table with the mounting
point (3) facing upwards.
•
Remove the sanding paper (10) from the
sanding pad (9).
•
Loosen the Allen screw (7) using the Allen key
(5).
•
Remove the sanding pad (9) from the mounting
point (3).
•
Tighten the Allen screw (7) using the Allen key
(5).
Mounting and removing the saw blade (fig. B)
The saw blade must be used for sawing applications.
Mounting
•
Place the machine on a table with the mounting
point (3) facing upwards.
•
Loosen the Allen screw (7) using the Allen key
(5).
•
Remove the spacer (8).
•
Mount the saw blade (11) to the mounting point
(3).
•
Mount the spacer (8).
•
Tighten the Allen screw (7) using the Allen key
(5).
Removing
•
Place the machine on a table with the mounting
point (3) facing upwards.
•
Loosen the Allen screw (7) using the Allen key
(5).
•
Remove the spacer (8).
•
Remove the saw blade (11) from the mounting
point (3).
•
Mount the spacer (8).
•
Tighten the Allen screw (7) using the Allen key
(5).
Mounting and removing the scraping knife
(fig. B)
The scraping knife must be used for scraping
applications.
Mounting
•
Place the machine on a table with the mounting
point (3) facing upwards.
6
•
Loosen the Allen screw (7) using the Allen key
(5).
•
Remove the spacer (8).
•
Mount the scraping knife (12) to the mounting
point (3).
•
Mount the spacer (8).
•
Tighten the Allen screw (7) using the Allen key
(5).
Removing
•
Place the machine on a table with the mounting
point (3) facing upwards.
•
Loosen the Allen screw (7) using the Allen key
(5).
•
Remove the spacer (8).
•
Remove the scraping knife (12) from the
mounting point (3).
•
Mount the spacer (8).
•
Tighten the Allen screw (7) using the Allen key
(5).
USE
Switching on and off (fig. A)
•
To switch on the machine, slide the on/off
switch (1) to the front.
•
To switch off the machine, slide the on/off
switch (1) to the rear.
Setting the speed (fig. A)
The speed adjustment wheel is used for setting
the speed. The speed adjustment wheel can be
set to 6 positions.
The ideal speed depends on the application and
on the material to be worked.
Do not set the speed during use.
•
Turn the speed adjustment wheel (2) to the
required position.
Hints for optimum use
•
Clamp the workpiece. Use a clamping device
for small workpieces.
•
Draw a line to define the direction in which to
guide the accessory.
•
Firmly hold the machine by the grip.
•
Switch on the machine.
•
Wait until the machine has reached full speed.
•
Place the accessory on the workpiece.
•
Slowly move the machine along the pre-drawn
line, firmly pressing the accessory against the
workpiece.
Publicidad
Tabla de contenido
