Ferm HDM1028 Traducción Del Manual Original página 6

Description
The numbers in the text refer to the diagrams on
pages 2-3
Fig. A
1. On/off switch
2. D rill selection switch
3. Hammer selection lever
4. Chuck
5. Locking sleeve
6. Main grip
7. Auxiliary grip
8. Carbon brush cover
9. Lubrication point
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Mounting and removing the accessory
Fig. B
Do not use blunt drill bits or chisels.
Immediately sharpen or replace blunt
drill bits or chisels.
Mounting
• A pply a few drops of oil to the shaft of the
accessory.
• S lide the locking sleeve (5) to the rear.
• I nsert the accessory into the chuck (4).
• S ecure the accessory by turning it
counterclockwise until it locks into place.
• R elease the locking sleeve (5).
Removing
• S lide the locking sleeve (5) to the rear.
• R emove the accessory from the chuck (4).
• R elease the locking sleeve (5).
Mounting and removing the auxiliary grip
Fig. C
Mounting
• L oosen the auxiliary grip (7) by turning it
counterclockwise.
• M ount the auxiliary grip (7) by sliding it over the
chuck (4).
6
HDM1028 Ma 1611-07.indd 6
• T urn the auxiliary grip (7) to the required
position.
• T ighten the auxiliary grip (7) by turning it
clockwise.
Removing
• L oosen the auxiliary grip (7) by turning it
counterclockwise.
• R emove the auxiliary grip (7).
• T ighten the auxiliary grip (7) by turning it
clockwise.
Mounting and removing the dust collector
Fig. D
The dust collector prevents dust from entering the
machine when drilling into ceilings.
Immediately replace a damaged dust
collector.
Mounting
• I f necessary, remove the accessory from the
chuck (4).
• S lide the dust collector (15) over the shaft of
the accessory.
• I nsert the accessory with the dust collector
(15) into the chuck (4).
Removing
• R emove the accessory with the dust collector
(15) from the chuck (4).
• R emove the dust collector (15) from the
accessory.
4. USE
Switching on and off
Fig. A
• T o switch on the machine, press the on/off
switch (1).
• T o switch off the machine, release the on/off
switch (1).
Setting the operating mode
Fig. A & E
The drill selection switch and the hammer
selection lever must be set according to the
required operating mode. Refer to the table below
to set the required operating mode.
Setting
Fig. E
A D em
B Ham
C D rill
• T urn
ham
posit
Hints fo
• C lam
for s
• F irm
• S et t
• S wit
• D o n
mach
• S wit
mach
befo
5. C
M
Clean th
cloth, pr
the vent
dirt. Rem
cloth mo
solvents
etc. Che
syntheti
Checkin
Fig. A
The carb
If the ca
start to
• R em
screw
23/11/16 16:35