Publicidad
Idiomas disponibles
Idiomas disponibles
_ D uette and Triplette frame: basket, 2 rear
wheels, 2 front wheels.
INSTRUCTIONS
1• FITTING THE WHEELS: remove the four
protective caps, (two round and two square)
from the folded chassis, as in the figure.
2• WARNING: distinguish the front wheels (Fig. A)
from the rear wheels (Fig. B), as in the figure.
3• Fit the front wheels, which are shown in Figure
A, while the base is closed. It is necessary to
push the locking lever down (fig. B) and at the
same time push the hub onto the pin (fig. C).
Check that the wheels are properly attached
by pulling them in opposite directions.
4• To fit the rear wheels, repeat the action
carried out for the front wheels (sequence B
and C). The rear wheels can be identified by
the black teeth, as shown in figure A. Check
that the wheels are properly attached by
pulling them in opposite directions.
5• BRAKE: to activate the brake on the chassis,
push down with your foot on the brake bar
located on the rear wheels, as shown by the
arrows in the figure.
6• OPENING: activate the brake on the folded
chassis. Unfasten the tab, as in the figure.
7• Lift the handlebar in the direction of
the arrow (Fig. A). Press the handlebar
downwards until the final click (Fig. B).
8• Check that the opening is correct, as in the figure.
9• BASKET: fasten the basket on the chassis base,
as shown in the figure, at six specific points.
Attach the four buttons, to the front and rear,
as in figures A and B; then attach the two
Velcro strips to the chassis tube, as in figure C.
1 0•STEERING WHEEL: to guarantee good grip,
the steering wheel may adopt four different
positions. To adjust them, press the button as
in the figure.
1 1• STEERABLE WHEELS: the practical steering
wheel allows you to steer the front wheels. To
steer, move the lever on the steering wheel
to the right, as in figure A. To fix the wheels,
move the lever to the left, as in figure B.
1 2•EXTERNAL HANDLEBARS: the complete
chassis may be lifted using the central external
handles (Fig. A) and the rear handlebar (Fig.
B). The chassis must be lifted by two people.
Figure C shows the correct way to lift it.
1 3• WHEEL REMOVAL: press down on the lever
at the centre of the wheel, as shown by the
arrow in figure A, and simultaneously pull the
wheel towards you (Fig. B).
14• FOLDING: apply the brake and release the
seats. To fold the frame, lift both levers on the
solid handle (Fig. A) to release this, then push
the handle slightly forward (Fig B). With your
left foot, press the safety lever downwards
(Fig C) to unlock the handle fully.
15• Rotate the handle downwards (Fig. A). Close
the frame, fastening the latch tab to the
handle hook (Fig. B).
You can fold up the frame without releasing
the Pop-Up seats (both facing mom). To do this,
lower the backrest of both seats fully forward.
GANCIOMATIC SYSTEM
The Ganciomatic System is a fast and
convenient system that allows you to attach
the Pop-Up seat, the Primo Viaggio car seat,
and the Pop-Up Bassinet (sold separately)
to the frame's Ganciomatic Base in one easy
movement. Position them on the Ganciomatic
Base and press downwards on the product
with both hands until they lock into place.
Always apply the frame or stroller brake before
securing or releasing the products (refer to the
respective instruction manuals). Follow the
directions for specific product combinations.
WARNING: To ensure the product is stable,
we recommend always installing all the
Pop-Up seats. If for any reason you are
using the product with a single occupant,
we recommend you fasten all the seats in
any case, and make sure they are properly
docked. ENSURE THE CHILD RESTRAINT IS
PROPERLY DOCKED.
The footrest may only be raised when the
seat faces out from the frame.
DUETTE SW FRAME
16• DUETTE FRAME + 2 DUETTE/TRIPLETTE
POP-UP SEATS
Figures A, B, C and D show the positions in
which the seats may be installed.
Figure D shows the "cot" position; this is
obtained by lowering the backrest and raising
only the leg rest, keeping the footrest lowered
in the vertical position as shown in the figure.
17• DUETTE FRAME + DUETTE/TRIPLETTE
POP-UP SEAT + POP-UP BASSINET
Figure A shows the positions in which the
products may be installed.
18• DUETTE FRAME + 2 PRIMO VIAGGIO CAR
SEATS Figure A shows the positions in which
the products may be installed (facing mom).
19• DUETTE FRAME + PRIMO VIAGGIO CAR SEAT
+ DUETTE/TRIPLETTE POP UP SEAT
Figure A shows the positions in which the
products may be installed (facing mom).
- 13 -
Publicidad
