Filter replacement
Do not spread dust during filter replacement!
- Wear adequate filter mask;
- VERSION "M": seal the dust container with the appropriate cap (33);
- detach the vacuum head pushing the side hooks (11) (pic.7-8);
- turn the vacuum head upside down (pic.15);
- remove the filter frame (21) turning the hooks (22) (pic. 16);
- remove the filter cartdridges (pic. 17) and fit them into a sealed disposal bag;
- fit new filter (cod. 036.1108) cartridges in the filter frame (pic.18) and reassemble it on the
vacuum head.
Use genuine RUPES spare parts only.
Refer to www.rupes.com for parts code and authorized service centre
RUPES Spa. will not be held responsible for direct or indirect damages resulting from
non-compliance with the requirements of this manual.
TROUBLESHOOTING AND SOLUTION
Effects
The motor will not start
The vacuum does
not start automatically
Vacuum flow is insufficient
Dust from the exhaust (10)
Tools do not start
Insufficient Power for pneumatic tool
Red indicator on
Yellow indicator on (VERSION "E")
TOOL IDENTIFICATION PLATE
POSITION AND MEANING OF INFORMATION
1. Type of tool.
2. Nominal working voltage Volts (V).
3. Working frequency Hertz (Hz).
4. Class of protection.
5. Absorbed power Watt (W).
6. Power at socket (MAX) Watt (W).
7. Power max Watt (W).
8. Serial number.
9 .
structions.
1 0 .
2002/96/CE (WEEE) + 2003/108/CE and its implementation in national law, must not
be released into the environment or thrown away as domestic waste, but must be
disposed of at authorised recycling centres (contact the
for a list of places where the product may be disposed of according to the law).
Disposing of the product correctly contributes to protecting human health and safe-
guarding the environment. Any illegitimate disposal of the product will be punishable
by law.
Causes
No power
Power cord, switch or
motor defective
Electronic module
Bag full
One of the hoses or
accesso ries is clogged
Clogged filters
Filter cartridge torn ripped
3-way switch malfunction
Insufficient compressed air feeding
Ordinary maintenance limit exceeded
Max. liquid level exceeded
Read all this instructions before operating this product and save these in-
At the end of its useful life, the product, pursuant to European Directive
Solutions
Make sure the unit is plugged in
Contact an authorised service centre
Contact an authorised service centre
Check the filter bag
Check the flexible hose and the
accessories
Check the filters cartridges
Contact an authorised service centre
Contact an authorised service centre
Check air passage
Contact an authorised service centre
Empty the bin
relevant local authorities
12