Nevir NVR-5002 DD Manual De Instrucciones página 15

away from the wall for a proper space for good air circulation. When the refrigerator is
placed in a cupboard, the rear of the cupboard must be removed out for good circulation.
5. OPERATION
1. Before the refrigerator is plugged in, check the following:
-There must not be any damage on all electrical wire
-Earthing screw must be well fixed.
-Wall outlet must be properly earthed.
Be sure that everything is in normal condition and the refrigerator can be plugged in.
2. When operating for the first time
When operating is in normal condition and the refrigerator without any load until it auto
stops at the desired temperature, usually it takes 2 or 3 hours. Then set the thermostat
to the required setting and place foods in.
3. Temperature control
Refrigerator's temperature can be adjusted by turning the knob of the thermostat. The
closer to "5" position the knob is set, the lower the temperature becomes. A medium
setting is the most suitable for general operation. The position "5" is cool than the position
"3".
Refrigerator's temperature will vary depending on the quantity of foods stored and the
frequency of the door opening, In order to maintain good cooling efficiency and save
energy, We recommend you not to store too much foods and not to open the door too
frequently.
CAUTION: When the thermostat has been turned clockwise to "5"position, do not attempt
to turn it more over. Otherwise it will be damaged.
6.DEFROSTING
CAUTION:
Never use any sharp of metallic instruments (e.g. knives) to remove frost/ice from
the evaporator as this will damage the evaporator. A punctured evaporator will cause
serious problems.
14