Replacing The Lamp - Nevir NVR-5002 DD Manual De Instrucciones

-the power plug is firmly in the wall outlet.
-the mains power switch is off.
-the fuse is not burned out.
2. When the refrigerator does not cool enough:
-the thermostat is at the correct setting, there are too frequent and too long door openings.
3.When the foods are frozen:
-the thermostat is at the correct setting.
4. When the refrigerator operates too noisily:
-the refrigerator is not touching furniture that can transmit or amplify a noise or a vibration.
-the refrigerator properly levelled.
-the containers or solid packages stored inside are not touching each other.
-the mains supply is stable.
If you refrigerator is still not functioning properly after making the above checks, please
contact the sale dealer immediately.
Note: During the period of high humidity, moisture may form on the outside of the
refrigerator, it is not unusual. You may just wipe it up yourself.

11. REPLACING THE LAMP

1. Turn the thermostat to the off position "0" and disconnect from the mains.
2. Remove all the food from the top shelf of the fridge and pull it forwards slightly.
3. The lamp is in the back of the thermostat housing, remove the plastic lens by pressing
the front center of the lens whilst pulling upwards on the small lip on the bottom of the
lens at the front.
4. Unscrew the lamp in a clockwise direction and screw a new lamp into the lamp holder
in an anti-clockwise direction until finger tight.
5. Replace the lens by locating the rear lug and pressing home firmly.
6. Set the thermostat to your preferred setting and close the door.
18