1.
BACKWARDS SCAN
Press to perform a backwards scan during play mode.
2.
FORWARDS SCAN
Press to perform a forwards scan during play mode.
3. LCD
4. CUE
Press this button in play mode to return to the position at which playing started.
5. TIME
Press this button to switch the time display between the elapsed time, remaining time or total remaining
time.
6.
BACKWARDS SKIP
Use this button to go back to the beginning of the track.
7. SGL/CTN
Press this button to switch between single and continuous play modes.
8. +10
Press once to skip 10 tracks. Press again to go back 10 tracks.
9. PROG
Press to enter the program mode and to stop the CD.
10.
FORWARDS SKIP
Skip to the next track.
11. PITCH SLIDER
Use the slider to adjust the pitch. Slide up to increase, slide down to decrease.
12.
OPEN/CLOSE
Press to open or to close the disc tray. The tray cannot be opened during play.
13. FRAME SEARCH WHEEL
Turn the wheel to perform search mode during pause mode or pitch bending during play mode. While in
play mode, turn it clockwise to increase the pitch (+ 16%) or anticlockwise to decrease the pitch (- 16%).
14.
PLAY/PAUSE
Start the playing of the CD. Press once to start playing, press once again to set to pause, press once again
to resume playing.
15. PITCH –
Press this button to slow down the CD. Release the button to return to normal playing speed.
16. PITCH +
Press this button to accelerate the CD. Release the button to return to normal playing speed.
17. PITCH BUTTON
Press this button to enable or to disable the BPM adjustment with the pitch sliders.
18. PITCH INDICATOR
The indicators light during pitch mode.
19. LOOP
Press this button to set the loop start point. Press again to set the loop end point.
20. LOOP INDICATOR
The indicator lights when the loop mode is set.
• Control Unit Rear Panel (fig. 4)
21. CONTROL CONNECTOR
Connect to the REMOTE CONTROL CONNECTOR on the main unit using the included cable.
VDSCD2000_v7
6
HQ POWER