Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
Check the working conditions. Do not
expose your bandsaw to rain. Never
use it in damp or wet locations.
Make sure there is good lighting.
Do
not
use
flammable liquids or gases.
•
Guard against electric shock! Avoid
body contact with earthed components.
•
Keep other persons away.
Do not allow other persons, particularly
children, to touch the machine or the
cable. Keep them away from your work
area.
•
Store tools in a safe place. When tools
are not in use they should be stored in
a dry, locked room out of children`s
reach.
•
Do not overload your machine. Your
bandsaw works better and safer when
used
within
range.
•
Use a machine with insufficient power
for a job at hand. Never use your
bandsaw for on jobs for which it was
not untended.
•
Wear suitable work clothes! Do not
wear loose clothing or jewellery as they
might get caught in moving parts. Wear
a hair net if you have long hair.
•
Use personal safety equipment: ear-
muffs, safety goggles, dust mask when
working on dusty jobs.
•
Connect the machine to a vacuum
extraction system!
•
Do not use the cable for purposes for
which it is not designed.
•
Avoid
abnormal
Make sure you stand squarely and keep
balance at all times.
•
Always pull out the power plug:
When the machine is not being used,
plug it out.
•
Remove adjusting keys, wrenches and
other tools from the working table after
use.
•
Always stay focused when working.
Reduce
distortion
working environment.
•
Check the ON/OFF Switch periodically.
•
Have repairs carried out only by a
qualified electrician. Have your power
connection
electrician.
the
bandsaw
their
quoted
capacity
working
postures!
sources
in
checked
by
a
qualified
•
Wear safety gloves whenever you carry
out any maintenance work on the
blade.
•
In the case of mitre cuts the parallel
guide must be placed at the lower place
near
of the working table to hold the
workpiece.
•
A
minimum air velocity of 20m/min shall
be connected to the bandsaw.
•
Give this operation manual to every
person who works with the machine.
•
DO NOT USE THIS SAW TO CUT
FIREWOOD.
•
The machine is equipped with a safety
switch to prevent it being switched on
again accidentally after a power failure.
•
Never dismantle the machine`s safety
devices or render them infunctional.
•
Let
replaced immediately.
•
Never cut workpieces that are too small
to be guided securely by your hand or
pushstick.
•
Never remove loose splinters, chips or
jammed pieces of wood when the saw
blade is running.
•
It is imperative to observe the accident
prevention regulations in force in your
country as well as all other generally
recognized rules of safety.
•
Position the blade guard so that it is
approx. 3mm above the material you
want to saw.
•
Secure long workpieces against falling
off at the end of the cut with a roller
table.
•
Make sure the blade guard is in its
lowest position when the machine is
being transported.
•
Blades that are deformed or damaged
have to be replaced immediately.
•
Worn table inserts have to be replaced
immediately.
•
Never start the machine when the door
protecting the blade is open.
your
•
Do not touch the blade until it has come
to a complete stop.
•
IMPORTANT:
INTENDED ONLY FOR HOME AND DO-
IT-YOURSELF
MACHINE
PROFESSIONAL USE.
dust
collecting
system
unreadable
safety
THIS
HOBBY
IS
NOT
DESIGNED
ENGLISH
with
a
stickers
be
BANDSAW
IS
USE.
THE
FOR
Publicidad
Tabla de contenido
