Assembly - General Motors ARIV MELD Manual De Instrucciones

3. Assembly

Unbox the ARĪV Meld. Be sure to save the carton and all packaging materials in case it is needed for future use.
NOTICE: Please review the ARĪV assembly video on www.arivmobility.com if you are unsure of these next
steps.
Locate the hex torque wrench and pedal wrench in the parts box.
• Turn the handlebar so it is perpendicular to the front wheel.
• Ensure there is a 2mm gap between the steer and the display. Using the hex wrench tighten the steerer bolts to
12 Nm.
• Place the plastic cover over the opening and snap into place.
CAUTION: Ensure the steerer bolts are tight by standing with the front wheel between your legs. Twist the
handlebar left and right to ensure it does not move.
Locate the pedals and identify which pedal is the right pedal and which pedal is the left pedal.
•
• Assembly the right pedal by hand on the chainring or right side of the bike. Install in a clockwise direction.
Using the pedal wrench tighten the pedal against the crank arm.
•
• Assemble the left pedal by hand on the left side of the bike or non-drive side. Be sure to tighten in a counter-
clockwise direction.
• Using the pedal wrench tighten the pedal against the crank arm.
Ensure both pedals are tight!
•
CAUTION: Be sure to properly identify the right and left pedals and ensure they are tightened in the correct
direction!
• Check the tire pressures. Start with 100 psi in the back and 90 in the front. Adjust for comfort depending upon
your body weight, etc.
• Set your saddle at the desired height (see General Owner's manual for these instructions).
Charge your seat post lights at this time using the provided USB cable (see below for further info on this).
•
• Download the app and install the provided universal Quad Lock female piece onto the back of your cell phone
(not required if you already have a Quad Lock case).
• Connect your phone to the bicycle (see Quick Start Guide).
6
EN